Govee Glide HEXA Light Panels (10 Pack) Setup Guide

Govee Glide HEXA Light Panels (10 Pack)

Tools required:
- Tape measure or ruler
- Pencil or low-tack marker for marking positions
- Spirit level or straight edge
- Small screwdriver (if mounting hardware requires screws)
- Cleaning cloth and isopropyl wipe or mild detergent
- Ladder or step stool (if mounting above reach)
- Optional: mounting putty, double-sided mounting pads or screws and anchors (use per wall type and manufacturer guidance)
Applications:
- Not specified

Setup steps (follow these in order; read the included user manual for any model-specific instructions)

Unbox and verify contents
Remove all items from the box and confirm you have ten hexagonal panels, any connectors, the controller or power module (if supplied), mounting accessories and the user manual. The product is described as a pack of 10 modular hexagonal LED panels intended for indoor ambient and accent lighting.
Plan the layout
Lay the panels on the floor and arrange them into your intended layout. Measure the wall area and mark the approximate location of the full layout. Decide the orientation of each hexagon and the route for any connecting cables so connectors will reach without strain.
Check mounting surface
Ensure the selected wall is clean, dry and smooth. Remove dust and grease with a cloth and appropriate cleaner. For painted or delicate walls, test a small area if you will use adhesive pads. If using screws, choose appropriate anchors for the wall material.
Test-fit panels
Temporarily position panels on the wall using low-tack mounting putty or by holding them in place to verify spacing and alignment. Use a spirit level or straight edge to keep the main lines straight. Adjust marks as needed.
Mount panels
Follow the manufacturer’s recommended mounting method: attach adhesive pads or secure the supplied hardware. Mount one panel at a time, checking alignment as you go. Connect panels using the supplied connectors; ensure connectors click or seat fully so there is no tension on cables. Keep spacing consistent between panels.
Connect power and controller
If a controller and power supply are included, connect the panel assembly to the controller, then plug the power supply into a mains socket. Do not alter wiring. The input method and controller type are not specified in the product information; follow the included manual for the correct power and control connections. If installation requires hardwiring to mains (not specified), have a trained electrician perform that work.
Initial power-up and configuration
Power on the system. If the product uses a remote control, onboard buttons or an app, follow the manual for pairing and initial setup. Connectivity method (for example Wi‑Fi or Bluetooth) is not specified in the supplied information; consult the included documentation to complete any wireless setup, firmware updates or app pairing steps.
Verify every panel
Confirm all ten panels light and respond to control inputs. If one or more panels fail to illuminate, recheck connector seating and power connections. Do not force connectors; remove power before reseating if necessary.
Final adjustments
Tidy any visible cables along the wall using cable clips or channels. Ensure panels are secure and evenly spaced. Adjust brightness and colour settings using the controller or app as instructed in the manual.
Safety and maintenance
Use indoors only. Keep panels away from moisture and direct heat sources. Clean with a dry or slightly damp cloth; do not immerse or use strong solvents. Do not attempt to open or modify LED panels or the power module; repairs should be performed by qualified personnel.

Capabilities and connectivity notes
The product is described as modular hexagonal LED panels suitable for ambient and accent lighting and intended for multi-panel installations. Specific connectivity and control methods are not specified in the provided product information; follow the included user manual for details on controllers, wireless setup and compatible applications.