Bold Smart Door Clicker for the Bold Smart Cylinder Lock Setup Guide

Bold Smart Door Clicker for the Bold Smart Cylinder Lock

Capabilities: remote door unlocking; secure access control; compact and easy to carry. Connectivity: not specified. Compatibility: compatible with Bold Smart Cylinder Lock.

  • Tools required:
    • Small flathead screwdriver or a coin (only if the clicker casing requires prying to access a battery compartment)
    • Clean, well-lit workspace and a soft cloth to protect the device while handling
    • Manufacturer documentation for the Bold Smart Cylinder Lock (for pairing instructions)
  • Applications:
    • Not specified — use the Bold Smart Cylinder Lock app or control system if your lock installation includes one

Setup steps (follow each step in order):

  • Step 1. Unpack and inspect the clicker. Confirm the product is the Bold Smart Door Clicker and that there is no visible damage. Check the clicker for any printed markings that indicate battery type or polarity.
  • Step 2. Prepare the battery (if applicable). If the unit requires a battery, refer to markings or the Bold product documentation to determine the correct type and orientation. Do not guess battery type; consult the supplied paperwork or the lock manufacturer.
  • Step 3. Install the battery (if present). Open the battery compartment using a coin or small flathead screwdriver only if the design requires it. Fit the battery observing polarity markings, then close the compartment securely. Wipe the device clean of fingerprints before pairing.
  • Step 4. Verify the Bold Smart Cylinder Lock is powered and within range. The clicker is compatible with the Bold Smart Cylinder Lock; ensure the lock is fitted correctly and any locking system or app is ready for pairing. If your lock has a dedicated app or control panel, open it and follow its procedure to put the lock into pairing or learn mode.
  • Step 5. Put the clicker into transmit mode. Press the clicker button once (or follow the physical action described in the Bold documentation) to send a pairing signal. Exact button-press instructions are not specified here; use the manufacturer’s guidance if the device has a specific sequence.
  • Step 6. Complete pairing at the lock. While the lock is in its learn mode, activate the clicker so the lock can detect the signal. The lock should confirm reception (usually via LED, chime, or app notification). If the lock does not acknowledge, repeat the lock’s learn-mode procedure and try again from within 0.5–1 metre distance.
  • Step 7. Test functionality. After successful pairing, test the clicker at short range and then at typical operating distance. Confirm the lock unlocks/relocks as expected and that response is consistent.
  • Step 8. Add additional clickers (if required). If you have multiple clickers to register, repeat the lock’s learn-mode steps for each unit one at a time.
  • Step 9. Troubleshooting. If pairing fails: replace the battery with a known-good cell (following markings), reduce distance between clicker and lock, ensure there are no dense obstructions, and repeat the lock’s pairing steps. If problems persist, consult Bold product documentation or your installer for device-specific pairing and diagnostics because connectivity details are not specified here.
  • Step 10. Final checks and placement. Label the clicker if needed, keep spare batteries in a safe place, and store unused clickers away from strong magnetic fields or liquids. Keep out of reach of children.

Notes and important information: do not attempt electrical work on mains wiring for the lock; this clicker itself does not require mains voltage. If your lock installation requires wiring or electrician work, that must be performed by a trained electrician. For any functions or app integration not described here, refer to the Bold Smart Cylinder Lock documentation or contact the installer. Connectivity specifics (protocol, frequency, encryption) are not specified in the product description and must be confirmed from Bold.